With this commit, the status-led is set to be the "led-running"
device-tree alias for targets which do not implement the get_status_led
method in /etc/diag.sh.
This adds previously absent ath10k packages definitions. This way,
devices correctly select CandelaTech firmware correctly, when
GLUON_WLAN_MESH is set to IBSS.
This is also necessary for all devices, when OpenWrt is switched to
19.07.
This adds a warning that entprise switches with an IGMP/MLD snooping
feature are not supported yet with IGMP/MLD filtering enabled.
For this to work, firstly the Linux bridge on the Gluon node needs to
support Multicast Router Discovery (RFC4286). But this feature was only
added to the Linux kernel recently, in 5.1.
Secondly, a Gluon node would need to periodically send "Multicast Router
Advertisment" (RFC4286) messages, to "announce" the multicast router
port setting on bridge port bat0.
Thirdly, the IGMP/MLD snooping switches would need to implement
RFC4286.
This reverts commit 9b1eb40fe7.
With the batman-adv v2019.2 upgrade reverted (c1a7733956), the batman-adv
multicast-to-multi-unicast feature is not available yet. Without that it is
going to be very unlikely of the batman-adv multicast optimizations to
take effect. E.g. some outdated nodes would disable it.
To avoid confusion and diversion with a few communities having it enabled
and most implicitly deactivated, just deactivate it for all for now
until batman-adv is updated to v2019.2 or greater again.
The kernel partition on these devices is too small for the
OpenWrt 19.07 kernel. It is also located after the rootfs, so
we cannot grow it further.
Therefore mark these devices as deprecated now.
This adds documentation for the gluon-mesh-batman-adv package and
elaborates on its build and configuration options, as well as
the implemented multicast architecture.
Signed-off-by: Linus Lüssing <linus.luessing@c0d3.blue>
e130b6f54d0f simple-tc: increment PKG_VERSION
89260206971f libbabelhelper: bump version to allow specifying the command for readbabeldata()
0447a6960caf bump mmfd: Bugfix Crash and firends
mac_to_ip() calculates an ipv6 address from a mac address according to
RFC 4291. For wireguard we have to use specially crafted addresses that
must be unique. This allows calculating such unique mac-based addresses
by allowing to optionally specifying the bytes to be inserted into the
address.
The new routing_algo site.conf value BATMAN_IV_LEGACY is introduced. With
these changes, the routing_algo setting becomes mandatory.
Signed-off-by: Linus Lüssing <linus.luessing@c0d3.blue>
We cannot add the same file (here: /lib/gluon/mesh-batman-adv/compat) to
two, installed packages. Therefore, instead of determining the compat
version number from this file, infer it from the batman-adv release
version number instead.
Signed-off-by: Linus Lüssing <linus.luessing@c0d3.blue>
Instead of unconditionally loading this module on boot the gluon_bat0
netifd protocol script will later take care of loading either the
batman-adv or batman-adv-legacy module, depending on the configured routing
algorithm in UCI.
