Gluon 2022.1.3 ============== Bugfixes -------- * Ipq40xx Wave2 devices temporarily use non-ct firmware again to work around 802.11s unicast package loss in ath10k-ct (`#2692 `_) * Modify kernel builds slightly to work around a boot hang on various devices based on the QCA9563 SoC - especially the Unifi AC-* devices (`#2784 `_) * Work around an issue with wifi setup timing by waiting a bit while device initialisation is ongoing (`#2779 `_) Known issues ------------ * Upgrading EdgeRouter-X from versions before v2020.1.x may lead to a soft-bricked state due to bad blocks on the NAND flash which the NAND driver before this release does not handle well. (`#1937 `_) * The integration of the BATMAN_V routing algorithm is incomplete. - Mesh neighbors don't appear on the status page. (`#1726 `_) Many tools have the BATMAN_IV metric hardcoded, these need to be updated to account for the new throughput metric. - Throughput values are not correctly acquired for different interface types. (`#1728 `_) This affects virtual interface types like bridges and VXLAN. * Default TX power on many Ubiquiti devices is too high, correct offsets are unknown (`#94 `_) Reducing the TX power in the Advanced Settings is recommended. * In configurations without VXLAN, the MAC address of the WAN interface is modified even when Mesh-on-WAN is disabled (`#496 `_) This may lead to issues in environments where a fixed MAC address is expected (like VMware when promiscuous mode is disallowed).