b359ed1887
many AVM devices do not have RESET/WPS buttons. So use the otherwise unused DECT/PHONE button to boot the device into setup mode. This patch allows to enter the setup-mode by pressing the phone button (often labeled as DECT) in addition to WPS and reset button. This patch is necessary to allow supporting boards without a WPS and reset button (e.g. AVM FRITZ!Box 7312).
38 lines
1.1 KiB
ReStructuredText
38 lines
1.1 KiB
ReStructuredText
Config Mode
|
|
===========
|
|
|
|
When in Config Mode a node will neither participate in the mesh nor connect
|
|
to the VPN using the WAN port. Instead, it'll offer a web interface on the
|
|
LAN port to aid configuration of the node.
|
|
|
|
Whether a node is in Config Mode can be determined by a characteristic
|
|
blinking sequence of the SYS LED:
|
|
|
|
.. image:: node_configmode.gif
|
|
|
|
Activating Config Mode
|
|
----------------------
|
|
|
|
Config Mode is automatically entered at the first boot. You can re-enter
|
|
Config Mode by pressing and holding the RESET/WPS/DECT button for about three
|
|
seconds. The device should reboot (all LEDs will turn off briefly) and
|
|
Config Mode will be available.
|
|
|
|
|
|
Port Configuration
|
|
------------------
|
|
|
|
In general, Config Mode will be offered on the LAN ports. However, there
|
|
are two practical exceptions:
|
|
|
|
* Devices with just one network port will run Config Mode on that port.
|
|
* Devices with PoE on the WAN port will run Config Mode on the WAN port instead.
|
|
|
|
|
|
Accessing Config Mode
|
|
---------------------
|
|
|
|
Config Mode can be accessed at http://192.168.1.1. The node will offer DHCP
|
|
to clients. Should this fail, you may assign an IP from 192.168.1.0/24 to
|
|
your computer manually.
|